Skip to content
Structures Technician – Falcon 9
| Company | SpaceX |
|---|
| Location | West Athens, CA, USA |
|---|
| Salary | $23 – $38 |
|---|
| Type | Full-Time |
|---|
| Degrees | |
|---|
| Experience Level | Junior |
|---|
Requirements
- High school diploma or equivalency certificate
- 1+ years of experience in hardware assembly, test, maintenance, material handling, and/or installation OR certificate from an accredited trade skills program in A&P, manufacturing, and/or electronics
Responsibilities
- Modify, repair, assemble, and install rocket and spacecraft components and subcomponents
- Use tooling holes, pilot holes, or by hand (as required), per drawing or tooling instructions
- Align parts and secure in place using clecos or tooling/hand clamps
- Install fasteners in correct sequence per drawing, using correct tools (e.g., rivet gun and bucking bar, drill motor, power screwdriver, C-squeeze, ratchet wrench, nut runner)
- Shim and/or trim parts as required
- Select drill bits, reamers and/or countersinking tools for pilot and full-size holes
- Locate, drill pilot holes using drill motor and proper size drill bit(s)
- Drill, ream, countersink full size holes in parts/assemblies, in proper sequence and to correct size using drill motor
- Set countersinking tools to proper depth as required
- Disassemble parts and deburr holes using chip chasers, deburring tools, and files to prepare for installation of fasteners
- Use solvents to clean surfaces prior to sealing or assembly
- Apply sealant, Alodine, primer, adhesives, special finishes
- Load and unload ovens to bond detail parts to assemblies
- Determine and obtain correct type and size fasteners
- Cold work holes to prepare for close tolerance fastener installation
- Install bushings into housings using arbor press and/or hydraulic puller
- Apply liquid nitrogen to facilitate installation of bushings
- Check work after completion of each operation in job and/or completed job to ensure it is complete per drawing
Preferred Qualifications
- Experience drilling, reaming, honing and/or countersinking straight and close tolerance holes
- Experience gained through the military or within an aviation manufacturing company
- Experience using various types of hand tools and/or hand-held power tools, floor-mounted power tools and precision measuring tools
- Capable of visualizing a three-dimensional shape from a two-dimensional view and understanding symbols, flag notes, and general notes
- Ability to perform basic arithmetic calculations accurately (addition, subtraction, multiplication, division, decimals and fractions)
- Experience making basic layouts on parts or assemblies in order to establish reference points and to check dimensions
- Experience reading and interpreting engineering drawings, blueprints, and specifications
